Extron Electronics VN-Matrix 200 Series - Manual (Page 32)

Interface timeout and logging out
If the web interface is left unattended or is not used for a period of 30 minutes it will
automatically logout. You can start using the interface again by re-entering your login
details.
To logout of the web interface…
Click the Logout tab on any page or close the web browser.
Save All tab
On the Device List page only, there is a Save All tab.
Clicking the Save All tab will save all current settings (including those that have been
updated) for all VNC 200 units.
Configuring a VNC 200 as an Encoder (Source)
The following procedure assumes that a valid source is connected to the VNC 200. For
details on how to connect a source, see “
Setup and Connection Procedure ”.
NOTE: This procedure provides a basic level of configuration which will be
adequate for most systems. For additional options, see “ Advanced Setup
Procedures .”
Figure 17. Configuring a VNC 200 as an Encoder
a
On the Device List page, click the device that you want to configure. The Device page
will appear.
b
If the device has not been configured (Device Type is none), click the create source
button (see Device Setup Mode on the Help tab).
TIP: You can change the default device name to be more relevant to the source
input (for example, Camera1). See Ç below.
VN-Matrix 200 Series • System Configuration 27