Extron Electronics VN-Matrix 200 Series - Manual (Page 64)

1
22
33
Figure 42. Setting the EDID Mode
To set the EDID mode, perform the following steps:
1. From the web interface, select the VN-Matrix defined as an encoder (source) device.
2. Click the videoPort0 icon.
3. Click the Configure tab.
4. Select the appropriate EDID mode. In most cases, Transparent will be the correct
option. This will allow the EDID data of the display to pass through the matrix to the
source PC.
5. Reboot the source PC to ensure it reads the proper EDID selection.
VN-Matrix 200 Series • Advanced Setup Procedures 59