Extron Electronics VN-Matrix 200 Series - Manual (Page 13)

Front Panel Features
VN-MATRIX 200 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
Figure 8. VN-Matrix 200 Front Panel
Indicators
The following indicators are visible on the front of the VNC 200:
Name Color Function
POWER -
Green • Fully Lit – When the unit is receiving power from the 12V supply input.
• Flashing – An over temperature condition has occurred or there was a power
overload or underload condition. Cycle the power off and then on to reset.
LAN - 1 Orange Indicates the status of network port 1:
• Fully Lit or Flashing Intermittently – Control or source data is being
transmitted or received by the port.
• Unlit – No data or no network connection detected.
LAN - 2 Orange Indicates the status of network port 2:
• Fully Lit or Flashing Intermittently – Control or source data is being
transmitted or received by the port.
• Unlit – No data or no network connection detected.
STATUS Green Indicates the source status of the VNC 200:
Condition Encoder (source) Decoder (display)
Unlit No source input detected No source being
received
Flashing Source being streamed Source being received
Fully Lit Source present but not being streamed
(that is, unit currently disabled or in
standby mode) N/A
NOTE: During the VNC 200 boot up period (typically 20-30 seconds) the NETWORK and STATUS indicators
may light up or flash intermittently while the unit initializes.
Reset Button
The VNC 200 is fitted with a concealed reset button on the front panel. This can be used
to reboot the operating system, for example, during firmware upgrade procedures.
To activate this button, insert the blade of a very small screwdriver (or similar tool) or
straightened paper clip into the hole on the front panel to the left of the LED indicators.
VN-Matrix 200 Series • Introduction 8