Extron Electronics VN-Matrix 200 Series User Manual
Page 53
Device Commands
mode
Changes the operating mode of the specified device.
• enable – for normal operation
• disable – to stop encoder source streaming or stop display output on a decoder
• standby – to stop encoder source streaming or display splash screen on a decoder
Example:
mode 16 enable
channel
Changes the source being displayed in a window of the specified decoder device.
• source id is the serial number of the source device
• videoport is the video input number, usually set to 0
• protocol specifies either RTP or TCP, set to 0 for RTP or 1 for TCP
Note: Full stops (.) are required between the sourceid, videoport, and protocol values.
Example:
channel 17 0 16.0.1
optimization
Changes the compression transform for the specified encoder device.
• video – for video sources
• graphics – for graphics sources
Example:
optimization 16 0 video
bandwidth
Changes the target bandwidth value for the specified encoder device.
<deviceid> Is the device serial number of the device or the user-defined device name.
<videoport> Is the video input number, usually set to 0.
<bandwidth> Is the bandwidth value in megabits per second.
Example:
bandwidth 16 0 5
Response Messages
All commands (except for
user
and
exit)
will generate an
OK
response message if the
command is successfully executed.
Unrecognized commands or invalid command parameters will generate an error message
in the format
fail:
followed by a brief description of the error, for example
fail:
unknown command
.
VN-Matrix 200 Series • Serial Transport and Control Methodsl
48