Extron Electronics IPI 200 Series User Guide - Manual (Page 75)

B-17 IPI 100 and IPI 200 Series • SIS Programming and Control
Command ASCII (Telnet)
(host to intercom)
URL Encoded
(host to intercom)
Response
(intercom to host)
Additional Description
Reset (zap)/Erase Commands
Erase all files
from flash
memory E
ZFFF
}
WZFFF
|
Zpf
]
Reset all
devices
settings to
factory presets E
ZXXX
}
WZXXX
|
Zpx
]
N Excludes IP settings such as IP address, subnet mask, gatewate IP address and IP Security-level table. User files in flash memory
will not be deleted.
Reset all
device settings
and delete
files E
ZY
}
WZY
|
Zpy
]
N This is an absolute system reset but excludes IP settings such as IP address, subnet mask, gateway IP address, unit name,
DHCP setting and port mapping (Telnet/Web/direct access) in order to preserve communicaiton with the device. This reset is
recommended after a firmware update.
N The ZY command appears n kernel versions 1.45 or higher.
Absolute
system reset E
ZQQQ
}
WZQQQ
|
Zpq
]
N (Mode 5 reset) Resets alls device settings, including IP settings, to factory default. Also rerases flash memory. Firmware version
remains the same.