Extron Electronics IPI 200 Series User Guide - Manual (Page 13)

IPI 100 and IPI 200 Series • Preface 1-5
System Requirements
The IP Intercom HelpDesk software is available at no charge via the Extron Web
site ( www.extron.com ) or the DVD that comes with your IPI. To install and run IP
HelpDesk, you need a PC that meets the following minimum requirements:
• Microsoft
® Windows XP
• Pentium ® 4, 2 GHz or faster microprocessor
• At least 512 MB RAM
• 500 MB or more available hard disk space
• Windows‑supported sound card, microphone, and speakers
• Microsoft Direct X version 9.0c or later
• Microsoft .NET framework, version 2.0 or later
• Network card and a network connection
INTERCOM MIC ON
IPI 204
PUSH TO TALK
1 2 3 4
ROOM
101 LAB ADMIN
OFFICE
HELP
DESK
CONFIG
IPI 204 Extron
INTERCOM
MIC ON
IPI 204
PUSH TO TALK
1 2 3 4
ROOM
101 LAB ADMIN
OFFICE
HELP
DESK
CONFIG
INTERCOM MIC ON
IPI 201
PUSH TO
TALK
HELP
DESK
CONFIG
IPI 201 Extron
INTERCOM
MIC ON
PUSH TO
TALK
HELP
DESK
CONFIG
UL Requirements
W Installation and service must be performed by authorized personnel only.
This product should be used with a UL approved electrical box.
1. This unit is not to be connected to a centralized DC power source or used
beyond its rated voltage range.
2. The IPI 100 AAP or IPI 200 AAP must be installed in a UL listed junction box.
The UL approved electrical wall box (junction box) is not included with the IPI;
the installer is responsible for obtaining and installing the box.
3. The unit must be installed in accordance with the National Electrical Code and
with local electrical codes.