Sis programming and control, cont’d – Extron Electronics IPI 200 Series User Guide User Manual
Page 70
SIS Programming and Control, cont’d
IPI 100 and IPI 200 Series • SIS Programming and Control
B-12
Command
ASCII (Telnet)
(host to intercom)
URL Encoded
(host to intercom)
Response
(intercom to host)
Additional Description
Read verbose
mode status
E
CV
}
WCV
|
X2@
]
Set the
broadcast
interval
24
E
X6$
,
X1$
EB
}
W
X6$
%2C
X1$
EB
|
Bmd
X6$
,
X1$
]
X6$
= Broadcast repetition interval
in seconds (0 to 255 [4.25 minutes],
default = 0 = off).
X1$
= subnet address (xxx.xxx.xxx.
xxx). Default broadcast address:
255.255.255.255.
Set broadcast
interval
to default
address
24
E
X6$
EB
}
W
X6$
EB
|
Bmd
X6$
,
X1$
]
X1$
= Default broadcast subnet
address: 255.255.255.255.
Clear
broadcast
interval
24
E
0 EB
}
W 0 EB
|
Bmd
X6$
,
X1$
]
X6$
= Broadcast repetition interval
set to 0 (off).
X1$
= Default broadcast subnet
address: 255.255.255.255.
View
broadcast
interval
E
EB
}
W EB
|
X6$
,
X1$
]
Set broadcast
port
E
{port#}*
X7!
,
X7@
PB
}
Bpt {port#}*
X1*
]
W{port#}*
X7!
,
X7@
PB
|
View
broadcast port
and MAC
E
PB
}
WPB
|
{port#}*
X1*
]
N
{port#} = UDP outgoing port,
X7!
*
X7@
= MAC address for UDP unicast transmissions.
N
Changes to the PB command become effective in kernel versions 1.53 or higher.
Get
connections
listing
E
CC
}
WCC
|
verbose modes 0/1: {# of
connections}
]
verbose modes 0/1: Icc {# of
connections}
]
Password and security settings
Set
administrator
password
24
E
X3#
CA
}
W
X3#
CA
|
Ipa•
X4!
]
Clear
administrator
password
24
E
• CA
}
W%20 CA
]
Ipa•
]
Clear/remove all passwords
(administrator and user).
N
A user password cannot be assigned if an administrator password does not exist. Also, if the administrator password is cleared,
the user password is also cleared.
Read
administrator
password
E
CA
}
WCA
|
X4! ]
X2@
= verbose mode status:
0 = clear/none, default for Telnet connections; responses are not echoed to the host
1 = verbose mode is on, default for RS‑232 host control; responses are echoed to the host and displayed to the user
2 = send tagged responses for queries
3 = verbose mode is on and tagged responses are sent for queries.
X3#
= Administrator password has 4 to 12 alphanumeric characters and is case sensitive. Special characters (spaces, symbols) not
allowed.
X4!
=
Password displayed on screen. When the IPI connects to a host device via RS‑232, the password is shown. When the connection
is via IP, 4 asterisks are shown (or an empty field if no password has been assigned).