Extron Electronics IPI 200 Series User Guide - Manual (Page 71)

B-13 IPI 100 and IPI 200 Series • SIS Programming and Control
Command ASCII (Telnet)
(host to intercom)
URL Encoded
(host to intercom)
Response
(intercom to host)
Additional Description
Set user
password
14, 24
E X3#
CU
}
W
X3#
CU
|
Ipu•
X4! ] X3#
= user password
X4!
= Password displayed on
screen.
N A user password cannot be assigned if an administrator password does not exist. Also, if the administrator password is cleared, the
user password is also cleared.
Clear user
password
24
E
• CU
}
W%20CU
|
Ipu•
] This clears the user password only.
Read user
password E
CU
}
WCU
| X4! ]
Read
connection’s
security level E
CK
}
WCK
| X5@ ]
or
Pvl
X5@ ]
For
X5@
11 = user
12 = administrator
Remapping port designations
For security reasons the network administrator may wish to assign new/different port numbers to the controller’s Telnet, Web
browser, and direct access ports or to disable one or more ports. Typically Telnet uses port 23, Web access is via port 80 (HTTP),
and direct access is via port 2001.
C Do not set two or more ports to the same port number. Setting two ports to the same number could cause networking
conflicts and will also result in an E13 (invalid parameter) error.
N If you remap a port, you must set the port number to 1024 or higher, unless you reset the port to the default number or disable the
port by setting it to 0.
Set Telnet
port
24
E
{port#}MT
}
W{port#}MT
|
Pmt {port#}
] Set a Telnet port number that does
not conflict with any other ports.
Reset Telnet
port
24
E
23MT
}
W23MT
|
Pmt 00023
] Reset the Telnet port to port 23.
Disable Telnet
port
24
E
0MT
}
W0MT
|
Pmt 00000
] Disables the port.
Read Telnet
port E
MT
}
WMT
|
{port#}
]
Set HTTP
port
24
E
{port#}MH
}
W{port#}MH
|
Pmh {port#}
] Set a HTTP port number that does
not conflict with any other ports.
Reset HTTP
port
24
E
80MH
}
W80MH
|
Pmh 00080
] This resets the HTTP port to port 80.
Disable HTTP
port
24
E
0MH
}
W0MH
|
Pmh 00000
] Disables the port.
Read the Web
port map E
MH
}
WMH
|
{port#}
]
Set Direct
Access port
24
E
{port#}MD
}
W{port#}MD
|
Pmd {port#}
] Set a direct access port number that
does not conflict with any other
ports.
Reset Direct
Access port
24
E
2001MD
}
W2001MD
|
Pmd 02001
] This resets the direct access port to
port 2001.
Disable Direct
Access port
24
E
0MD
}
W0MD
|
Pmd 00000
] Disables the port.
Read Direct
Access port E
MD
}
WMD
|
{port#}
]