Xylem DH-21 - Manual (Page 39)

DH-21
Using the “W ATER LOG” Software 3-21
The WaterLOG Serial # T2000 Version 1.1
Status = OFF (VARIABLE) Last Measurement Units
Date/Time = 02/28/95 04:08:46
Date Started = 02/28/95 04:00:00 PRESSURE = -0.0052 PSI
Logging Rate = 00:01:00 TEMPERATURE = 78.07 Deg F
Next Log Time = 04:07:55
Memory Used = 0.1 %
Logging Count = 15 Scans
Battery = 6.8 Volts
1) Run 4) Time/Date 7) User Notes 10) Measure Data
2) Off 5) Logging Mode 8) Extract Data 11) Zero Sensor
3) Reset 6) Coefficients 9) View Data 12) Sensor Info
13) Diagnostics
Enter Option: 8 Esc-Exit
Extract ALL Data
Destination Filename: myfile1.dat Percentage complete: 100.0 %
Extraction complete. No errors.
Type any key to continue.
Figure 3-17. Extract ALL Data Option
Figure 3-18 shows a sample screen which is displayed during the Extract New Data process.
This option extracts all data recorded since the last time you extracted data. You can see the
percentage of completion as shown on the screen.
The WaterLOG Serial # T2000 Version 1.1
Status = OFF (VARIABLE) Last Measurement Units
Date/Time = 02/28/95 04:09:38
Date Started = 02/28/95 04:00:00 PRESSURE = -0.0052 PSI
Logging Rate = 00:01:00 TEMPERATURE = 78.07 Deg F
Next Log Time = 04:07:55
Memory Used = 0.1 %
Logging Count = 15 Scans
Battery = 6.8 Volts
1) Run 4) Time/Date 7) User Notes 10) Measure Data
2) Off 5) Logging Mode 8) Extract Data 11) Zero Sensor
3) Reset 6) Coefficients 9) View Data 12) Sensor Info
13) Diagnostics
Enter Option: 8 Esc-Exit
Extract NEW Data
Destination Filename: myfile2.dat Percentage complete: 100.0 %
Extraction complete. No errors.
Type any key to continue.
Figure 3-18. Extract NEW Data Option