Xylem DH-21 - Manual (Page 38)

3-20 Using the “W ATER LOG” Software
DH-21
Shown in Figure 3-16, the software running in the computer will cause the “ W ATER LOG” to
transfer the data to the computer, and place the data in a user specified file. The file name can be
up to 8 characters in length. The computer software will append a “.DAT” extension on the
filename. The data from the “
W
ATER LOG” FLASH EEPROM will be placed in the specified
file on the default disk drive.
The WaterLOG Serial # T2000 Version 1.1
Status = OFF (VARIABLE) Last Measurement Units
Date/Time = 02/28/95 04:08:46
Date Started = 02/28/95 04:00:00 PRESSURE = -0.0052 PSI
Logging Rate = 00:01:00 TEMPERATURE = 78.07 Deg F
Next Log Time = 04:07:55
Memory Used = 0.1 %
Logging Count = 15 Scans
Battery = 6.8 Volts
1) Run 4) Time/Date 7) User Notes 10) Measure Data
2) Off 5) Logging Mode 8) Extract Data 11) Zero Sensor
3) Reset 6) Coefficients 9) View Data 12) Sensor Info
13) Diagnostics
Enter Option: 8 Esc-Exit
Extract ALL Data
Destination Filename: myfile1
(1 to 8 characters)
Example : Logger10
Figure 3-16. Filename Input
Figure 3-17 shows a sample screen which is displayed during the Extract All Data process. This
process can take several minutes when the FLASH EEPROM is full of data. The format of this
file is described in chapter 5 “Guide to Data Analysis”. You can see the percentage of
completion as shown on the screen.