GE Industrial Solutions Galaxy Vector Controller GCM3 - Manual (Page 98)

Galaxy Vector Controller GCM2, GCM3
Appendix B - 6 T1.317 Objects and Attributes Issue 4 January 2008
Commands
This section describes each of the remote access commands supported by this controller.
ala Report Active Alarms
Syntax ala
Description:
This command reports all the active alarm conditions in the plant. One alarm message is
listed per line in the report. The table below lists the alarm messages.
Table B-15: Alarm Messages
MAJ,Multiple Rectifier
MAJ,Multiple AC Fail
MAJ,Rectifier ID Conflict
MAJ,Very Low Voltage
MAJ,Battery On Discharge
MAJ,High Voltage
MAJ,Sense Fuse
MAJ,Multiple Converter Fail
MAJ,Converter Distribution Fuse
MAJ,Converter Fan Major
MAJ,Fuse Major
MAJ,Auxiliary Major
MAJ,Contactor 1 Open
MAJ,Contactor 1 Failed
MAJ,Contactor 2 Open
MAJ,Contactor 2 Failed
MAJ,Battery High Temp
MAJ,Open Connection
MIN,Rectifier Fail
MIN,AC Fail
MIN,Phase Fail
MIN,Manual Off
MIN,High Float Voltage
MIN,Converter Fail
MIN,Converter ID Conflict
MIN,Converter Fan Minor
MIN,Load Share Imbalance
MIN,Thermal Probe Failure
If no alarms are active "NO ACTIVE ALARMS" is reported.
bye Log-off
Syntax bye
Description:
This command is used to terminate remote access session. If the user is connected via a
modem, the controller will command the modem to hang-up the line.