Grain Systems Tanks PNEG-1460 - Manual (Page 58)

11. Roof Cap and Ground Control
58 PNEG-1460 6', 7' and 9' Bulk Feed Tank BFT Series and GHT Series
3. Thread the existing chain through the hole on the end of the lever arm and fasten it to the provided
key ring. (See Figure 11B on Page 56.) Ensure that the ground control chain is freely looped
through the roof eave bracket and chain holder. After removing the slack in the chain while the lid
is fully closed and in latched position, re-position the key ring 2" below the roof eave bracket.
(See Figure 11F.) Re-adjust the existing handle and key ring so the handle is positioned for easy
access from ground. (See Figure 11G.) Check to make sure that the key rings allow the cap to fully
close, but will not allow the chain enough slack on top of the cap to become wrapped around the lever
arm in a high wind condition.
Figure 11F
Figure 11G
Ref # Description Ref # Description
A Roof Eave Bracket (BLK-11950) C Chain Holder (BLK-11949)
B Key Ring D Handle
NOTE: Position handle for
easy access from ground.