EVS INSIO Version 1.1 - October 2010 User's Manual - Manual (Page 89)

Issue 1.1.B INSIO Version 1.1 – User Manual
EVS Broadcast Equipment – October 2010
80
As each clip is played from its TC IN point, the playback of each clip starts at
different moments to ensure that the temporary cue point of each clip will be
played at the same time.
Example:
2 clips have a TC Duration of 24 seconds.
Temporary Cue Point of clip 1 is set at ‘TC IN + 8 s’.
Temporary Cue Point of clip 2 is set at ‘TC IN + 11 s’.
When tapping the Play button, the playout of clip 2 starts 3 seconds before the
playout of clip 1; so, their temporary Cue Points are played at the same time.
Note
This function can only be used with Software Player channels, not with
server player channels.
How to Play Clips from Different Takes
To set a temporary cue point, proceed as follows:
1. Load up to 4 clips on Software Player channels.
2. Select the line corresponding to a loaded clip in the Review tab.
3. Move through the clip until you reach the image you want to set as
temporary cue point.
4.
Tap the Temporary Cue Point button at the end of the line.
The button turns blue when activated: .
5. Repeat steps 2 and 4 for the other clips.
6. Tap the Cue button to load each of the clips on their TC IN point.
7. Tap the Play button.
The playback of each clip is synchronized on all the temporary cue points.