EVS INSIO Version 1.1 - October 2010 User's Manual - Manual (Page 104)

INSIO Version 1.1 – User Manual
EVS Broadcast Equipment – October 2010
Issue 1.1.B
95
6.4 AUTOMATIC TRANSFER
The automatic transfer can only be performed from the Record tab, just after the
saving of recorded clip(s).
The Automatic Transfer mode can be activated in one of the following ways:
• from Setup > User > General > Default Auto Actions
• by tapping the Auto Transfer button in the Record tab of the Record/Review
window before or during the recording of a take.
The background color of the Auto Transfer button turns blue when the function is
activated:
An ‘Auto’ flag is present on the top of the Transfer button when the Auto Transfer
mode is activated:
The Auto Transfer mode can be deactivated by tapping the AutoTransfer button
again. The background color of the Auto Transfer button then turns grey and the
‘Auto’ flag is removed from the top of the Transfer button.
With the Auto Transfer mode activated, the linked clips of a recorded take will
automatically be transferred to the predefined transfer destination(s) as soon as
they are saved. Refer to section 5.3.3 ‘Recording a Take’ on page 61 for more
information.
6.5 MANUAL TRANSFER
Manual transfer of clips can occur at different times:
• just after the manual or automatic saving of a recorded clip. This is performed
from the Record tab, for all the clips saved from a take, when the Automatic
Transfer mode is not activated.
• when reviewing a recorded clip. This is performed from the Review tab, for the
single selected clip.
• at any times, by selecting clips in one of the Clip List tabs. In this case,
multiple clips can be selected.
Therefore, a Transfer button is present on the four tabs of the Record/Review
window, except the Metadata tab. The operator will have to tap the Transfer
button to initialize the transfer of clips to predefined transfer destinations.