EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 9)

1. Introduction
1.1. Introduction to the Configuration of
EVS Servers
Configuration Module
The Multicam Setup application is used for configuration and maintenance operations on
EVS video servers. It is also used to select which application to run, since EVS disk
recorders have the ability to run various dedicated applications (Video Server, Slow
Motion, …).
The configuration module available from Multicam 11.00 has been developed along the
lines presented in this section.
Consolidation into a Single User Interface
The server can be fully configured from a single user interface.
The user interface includes:
• a setup section presented on one page with two main areas which give access to the
configuration lines and the most used maintenance commands:
CONFIGURATION MANUAL XT2 Server 11.02
1. Introduction 1