EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 21)

In the Server-Based Application
To edit a configuration line in the server-based application, proceed as follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Press F8.
The Configuration window opens. See section "Multicam Configuration" on page 44 to
edit the configuration parameters.
3. When the configuration is defined for a given line, press ALT+A in the Configuration
window to validate the changes
4. Press ESC to come back to the Setup window.
In the Web-Based Interface
To edit a configuration line in the web-based interface, proceed as follows:
1. Click the Edit icon for the configuration line you want to configure.
The Configuration window opens. See section "Multicam Configuration" on page 44 to
edit the configuration parameters.
2. When the configuration is defined for the given line, click Apply to validate, and then
Quit to come back to the Setup window.
Invalid Configuration
Invalid configuration lines are easily detected in the server-based application:
• When a configuration line becomes invalid, a red exclamation mark < ! > is displayed
next to the configuration line in both server-based and web-based interfaces:
• When the operator presses F8 to edit the configuration line in the server-based
application, a popup window indicates the line is invalid. When the operator
acknowledges the message, the pages including the invalid parameters are displayed
with the invalid parameters selected.
CONFIGURATION MANUAL XT2 Server 11.02
2. Multicam Setup 13