EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 208)

3.9.12. Cam Mapping Settings
User Interface
The Cam Mapping settings allow specifying the settings related to the mapping of
network cameras to unused camera positions on the remote up to the camera D.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Operation tab, in the basic display mode:
◦ on page 5 on the server-based application
◦ on page 1 on the web-based interface
• in the Operational setup menu of the Remote Control Panel (page 10.1)
Warning
The cam mapping feature and setting are only available if the license code 126,
which allows the mapping of additional cameras, is valid.
The following screenshot presents page 5 of the Operation tab in the server-based
application, where the Cam Mapping settings are available, and highlights the Cam
Mapping settings area:
Mapping of Network Cameras
This feature allows the mapping of network cameras to unused camera positions on the
remote (up to the last D camera).
The mapping allows a quick selection of network trains on the network. Nevertheless,
please note that these cameras are NOT recorded on the local server, they remain
recorded on their respective destination servers.
For example, in a 2IN 2OUT configuration, the cameras C and D are not used and thus is
possible to map up to 2 network cameras:
• Cam A and Cam B are local cameras.
200 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013