EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 74)

3.2.5. General Principles on 3D Configurations
Introduction
The 3D and 1080p configurations can be used on an XT2 server, using the following
connection interfaces:
• Dual Link interface, that is to say two connections (on a record or play channel) seen
by the EVS server as one logical channel.
Connections on the Rear Panel with COHX Boards
You can only use the primary link of a codec module on a COHX board. As each
3D/1080p channel consists of two inputs, each channel requires using two codec
modules:
• The first input is connected to the IN1 of a codec board.
• The second input is connected to the IN2 of the next codec board.
The same principle applies to the playout channels.
3.2.6. 3D/1080p Standard Configurations
XT2 4U Servers
Available Configurations
The tables below show the available 3D and 1080p configurations with standard cameras
on a XT2 4U server. They show the link assignment at the level of the codec module of a
COHX board.
#REC #PLAY
IN4/OUT1 IN3/OUT2 IN2/OUT3 IN1/OUT4
Prim.
Link Sec.
Link Prim.
Link Sec.
Link Prim.
Link Sec.
Link Prim.
Link Sec.
Link
1 0 REC1B REC1A
2 0 REC2B REC2A REC1B REC1A
0 1 PLAY1A PLAY1B
1 1 PLAY1A PLAY1B REC1B REC1A
0 2 PLAY1A PLAY1B PLAY2A PLAY2B
66 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013