Configuration lines, Chapter contents, Launching a configuration – EVS XT2 Version 11.02 - July 2013 Configuration Manual User Manual
Page 19: Introduction, How to manually launch a configuration
Tools Menu
To call a Tools command, simply click on the command in the Tools menu. This will open
the corresponding window.
2.2.
Configuration Lines
2.2.1.
Chapter Contents
The table below presents the topics of this section and shows whether the feature
described is available from the web-based interface and/or from the server-based
interface.
Section
Page
Server-Based
Web-Based
Yes
Yes
Yes
Yes
"Renaming Configuration Lines"
Yes
Yes
"Exporting and Importing Configuration Lines"
Yes
Yes
(one by one)
"Changing the Position of Configuration Lines"
Yes
Yes
(indirectly)
"Copying, Pasting and Deleting Configuration
Lines"
Yes
Yes
(indirectly)
2.2.2.
Launching a Configuration
Introduction
When the EVS server has initialized, the Multicam Setup window stays open, by default,
until the operator selects the requested configuration line and launches it.
How to Manually Launch a Configuration
In the Server-Based Application
To start a configuration in the server-based application, proceed as follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Press ENTER to run the configuration line on the EVS server.
CONFIGURATION MANUAL XT2 Server 11.02
2. Multicam Setup
11