EVS XT2 Version 11.02 - July 2013 Configuration Manual - Manual (Page 212)

Recorder
Description Selects the record channel to which the A/V material from the
hypermotion camera will be sent.
Values CAM A to CAM D
Default Values The default value is the last CAM defined in the channel
configuration (for ex. CAM C in a 3 IN 3 OUT configuration).
Remote mode
Description Specifies the camera elements controlled by the server.
Values • Hypermotion only:
The server controls only the hypermotion camera. An
additional remote is made available in the main menu of the
remote panel, since the hypermotion camera is considered
as an additional external camera.
• Hypermotion + LSM:
The server controls the hypermotion camera and one PGM
in exclusive mode.
Default value Hypermotion only
Port
Description Specifies on which port (RS422 or Lan PC) the commands
must be sent to the hypermotion camera, and possibly to the
PGM if you have selected ‘Hypermotion + LSM” in the Remote
Mode parameter.
Values The following values are possible:
• RS422 #2 to RS422 #6
• Lan PC
Default value RS422 #6
Protocol
Description Specifies the protocol type used for data transfer on the
selected port.
Values The following values are possible:
• TCP / UDP (when Port is set to Lan PC).
• ASCII / Sony 9-pin (when Port is set to one of the RS422).
Default values • TCP (when Port is set to Lan PC).
• Sony 9-pin (when Port is set to one of the RS422).
204 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013