AASTRA 6739i User Guide EN - Manual (Page 115)

Options Key
41-001317-05 REV01 – 06.2013
109
Using the Park Call/Pickup Parked Call Softkeys
Use the following procedure on the IP phones to park a call and pick up a parked call.
Park a Call
Pickup a Parked Call
5. Select another key and In the "Type" field, select Pickup.
6. In the "Label" field, enter a label for the Pickup key.
Note:
The Pickup key applies in the “Idle” and “Outgoing” states only. Keep these states enabled to use the Pickup
softkey.
Expansion Module Keys
7. Select an expansion module key.
8. In the "Type" field, select Park.
9. In the "Label" field, enter a label for the Park key.
10. Select another key to configure for Picking up a call.
11. In the "Label" field, enter a label for the Pickup key.
12. Click Save Settings.
IP Phone UI
1. While on a live call, press the "Park" softkey.
2. Perform the following for your specific server.
For Asterisk Server
Server announces the extension number where the call has been
parked. Once the call is parked, press the
key to com-
plete parking.
For BroadWorks Server
After you hear the greeting from the CallPark server, enter the
extension where you want to park the call.
For Sylantro Server
Enter the extension number where you want to park the call, fol-
lowed by "#" key.
For ININ Server
Enter the extension number where you want to park the call, fol-
lowed by "#" key.
3. If the call fails, you can pick up the call (using the next procedure) and press the "Park" softkey again to retry step 2.
1. Pick up the handset on the phone.
2. Enter the extension number where the call was parked.
3. Press the "Pickup" softkey. If the call pick up is successful, you are connected with the parked call.