Global contacts – AASTRA BluStar 8000i BAS-Mode Administrator Guides EN User Manual
Page 71
Global Contacts
41-001391-00 Rev 03 – 04.2012
5-22
g)
On BAS Y, Services :: Clustering :: Inbound BAS Connections the status of BAS X changes to (Registered, Con-
nected).
5.
Enable Global Address Book Viewing on BAS Y. This will allow BAS X to obtain contacts from BAS Y. It will also allow
BluStar 8000i terminals on BAS Y to show the contents of BAS Y GAB:
a)
If BAS Y has a fresh install (not upgrade), then on BAS Y Users :: Global Contacts :: Global Contact Editor, you
should see the button Enable Global Address Book Viewing.
b)
If the previous step is seen, then on BAS X Users :: Global Contacts :: Global Address Book Sync, check that
(Last Sync: Never, Time Status: Remote BAS does not allow GAB Viewing).
c)
On BAS Y, go to Users :: Global Contacts :: Global Contact Editor and click on Enable Global Address Book
Viewing.
6.
If BAS Y does not have user accounts that BAS X can sync, create one:
a)
Go to BAS Y Users :: Global Contacts :: Global Contact Editor and click Add (you can do the same step by going
to Users :: User Accounts and clicking Add but make sure that the Save in Global Address Book is checked).
7.
Run the Sync on BAS X:
a)
Go to BAS X Users :: Global Contacts :: Global Address Book Sync
b)
Select BAS Y entry that you want to sync from and click Sync Now.
c)
The values of Last Sync Time and Status should change.