AASTRA BluStar 8000i BAS-Mode Administrator Guides EN - Manual (Page 128)

System Monitor Settings
8-13 41-001391-00 Rev 03 – 04.2012
SNMP Manager
Enter the address of the SNMP manager.
For SNMP version 3 notifications, you must configure an SNMP user for each SNMP manager that should receive the
notification traps. The user must also be configured on the SNMP manager.
User Name
User name for this SNMP user.
SNMP Manager
The address of the SNMP manager.
Authentication Protocol
The authentication protocol that this user will use. This protocol must match that running on the SNMP manager
that this user will access.
– NONE - No protocol is used.
– MD5 - The Message Digest 5 security protocol is used.
– SHA - The SHA security protocol is used.
Authentication Pass Phrase
The authentication password for the user.
Privacy Protocol
The encryption protocol that this user will use. This protocol must match that running on the switch that this user
will access.
– NONE - No protocol is used.
– DES - The Data Encryption Standard encryption protocol is used.
– AES - The Advanced Encryption Standard (AES) protocol is used.
Privacy Pass Phrase
The privacy password for the user.
MIBs Required to Process SNMP Traps
In the MIBs area, you can download the MIBs required for your SNMP manager to process the SNMP notification traps
issued by the BAS.