Zebra Technologies XiII-Series - Manual (Page 67)

3. Remove the faulty fuse and install a new fuse of the correct type. Refer
to Figure 13. The fuse that goes into the printer first is the one that is
“in-circuit”. If you use the spare fuse, be sure to order a replacement
fuse (fuses can be ordered from your Zebra distributor).
4. Snap the Fuse Holder back into position.
5. Reconnect the power cord.
If the new fuse fails right away, the printer has an internal component
failure and must be repaired.
Zebra XiII-Series User’s Guide 55
SMALL BLADE
SCREWDRIVER
AC POWER
ENTRY
MODULE
FUSE
HOLDER
Figure 12. Fuse Replacement—Step 1
SPARE
FUSE
FUSE
HOLDER
IN-CIRCUIT
FUSE
Figure 13. Fuse Replacement—Step 2
67
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:36:17 1998
Color profile: Disabled
Composite Default screen