Zebra Technologies XiII-Series - Manual (Page 17)

Site Requirements
CAUTION: To insure that the printer has proper ventilation and
cooling, do not place any padding or cushioning mate-
rial under the unit because this restricts air flow.
The Zebra XiII-Series printer may be installed on any solid, level surface of
sufficient size and strength to accommodate the physical dimensions and
weight of the unit. The area enclosure in which the printer will operate must
meet the environmental conditions specified. Electrical power must be
available and in close proximity to the printer.
Since the Zebra XiII-Series printer was designed and is fabricated as an
industrial-type unit, it will function satisfactorily in areas such as ware-
houses, factory floors, and office environments that conform to specified
environmental and electrical conditions.
Printer Power-Up
Follow the instructions in this section to connect this printer to a source of
electrical power and a data source.
Voltage Selection
The XiII printer auto-adjusts for 90-264 VAC electrical power. No further
adjustment is required.
Power Cord
WARNING! For personnel and equipment safety, always
use a three-prong plug with a ground (earth)
connection.
Make sure that the Power On/Off Switch (located at the back of the printer) is
in the off position before connecting the power cable to an electrical outlet.
Depending on how your printer was ordered, a power cord may or may not
be included. If one is not included, or if the one included is not suitable for
your requirements, refer to “Power Line Cord Specifications” on page 82.
The power cord connector must be plugged into the mating connector on
the rear of the printer.
Zebra XiII-Series User’s Guide 5
17
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:39 1998
Color profile: Disabled
Composite Default screen