Zebra Technologies XiII-Series - Manual (Page 25)

3. Insert the Hook Plate lip a short distance (½") into the lower opening in
the Side Plate and slide the Rewind Plate in so that it stops against the
printer’s main frame.
4. Insert the two small tabs on the Rewind Plate into the corresponding
slots in the Cutter Support Bracket. (The Rewind Plate should spring
into the proper position.)
5. Load the media as described in the instructions for Roll Media Loading
on page 9. When loading the media, allow about one yard of media to
extend past the Tear-Off bar. If using label stock remove all labels
from this portion of the media to create a leader.
6. Remove the Hook from the Rewind Spindle. If you are using a core, re-
move all tape from the core and slide it onto the Rewind Spindle until it
is flush against the guide plate.
7. Route the media as shown in Figures 1 and 2 and wind it once or twice
around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3"
core. (With some media, especially tag stock, you may need to tape the
end of the media to the core if it will not otherwise tighten onto the
core. DO NOT tape the label stock unless absolutely necessary.)
NOTE: Before closing the Printhead Open Lever, make sure that the
following guidelines are met:
n the media is positioned against the inside guides, and the outer guide
and Media Supply Guide barely touch the media
n the media is taut
n the media is parallel with itself and with the pathway when wound on
the Rewind Spindle/core
8. Media loading is now complete. See “Transmissive Media Sensor
Position Adjustment” on page 15.
Zebra XiII-Series User’s Guide 13
25
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:43 1998
Color profile: Disabled
Composite Default screen