Zebra Technologies XiII-Series - Manual (Page 55)

Press Display Shows Action/Explanation
HEAD TEST
COUNT
Setting the Head Test Count Press the left oval key to
move to the next digit position, press the right oval key to
change the value of the digit.
Default: 0000 (Disables the test)
Range: 0000 to 9999
The printer periodically performs a test of the printhead
functionality, called a “Printhead Test” or “Head Test”. This
parameter establishes how many labels are printed between
these internal tests.
HEAD RESISTOR
Setting the Head Resistor Value Press the left oval key to
move to the next digit position, press the right oval key to
increase the value of the digit.
CAUTION: This parameter should only be changed by
qualified personnel!
Initial Value: Factory-set to match the printhead shipped with
your printer (varries).
Default Value: 0500
Range: 0500 - 1175
This value has been pre-set at the factory to match the
resistance value of the printhead. It will not need to be
changed unless...
1) The printhead is replaced.
2) The printer is set to the factory defaults. (The factory default
value is usually lower than the actual resistance value.)
CAUTION: DO NOT set the value higher than that shown on the
printhead. Setting a higher value may damage the printhead!
Before replacing a printhead, look on the bottom of the
printhead element for the label that shows the resistance
value (ohm value).
VERIFIER PORT
Setting the Verifier Port Press the right or left oval key to
display other choices.
Default: Off
Selections: Off, 1 VER-RPRNT, 2 VER-THRUPUT
The Auxiliary Port is used to determine how the printer will
react to the Zebra On-Line Verifier. There are currently three
operating conditions for this port.
• Off—The Verifier Port is off.
• 1 VER-RPRNT ERR—Label reprinted if verifier detects an
error. If a bar code is near the upper edge of the label, the
label will be fed out far enough to be verified and then backfed
to allow the next label to be printed and verified.
• 2 VER-THRUPUT—Allows greatest throughput but may not
indicate a verification error immediately upon detection. May
print from 1 to 3 labels before an error is recognized and
printing stops.
For more information on the operation of the optional verifier,
refer to the documentation provided with that option.
Zebra XiII-Series User’s Guide 43
55
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:35:51 1998
Color profile: Disabled
Composite Default screen