Zebra Technologies XiII-Series - Manual (Page 65)

5. Rotate the platen roller and clean thoroughly with solvent and an
applicator.
6. Brush/vacuum any accumulated paper lint and dust away from the
rollers.
7. Reload ribbon and/or media, close and latch the printhead, close the
Front Panel and the Media Compartment Door, and continue printing.
Cleaning the Sensors
The Media, Ribbon, and Label Available Sensors should be cleaned on a
regular basis to ensure proper operation of the printer. To locate the position
of these sensors, refer to Figure 11 above, Figure 4 on page 16, and Figure 5
on page 17. Brush/vacuum any accumulated paper lint and dust off of these
sensors.
Zebra XiII-Series User’s Guide 53
RIBBON
SENSOR
BLACK
MARK
SENSOR
PEEL/TEAR
BAR
PLATEN
ROLLER LABEL
AVAILABLE
SENSORS
PRINTHEAD
Figure 11. Cleaning Diagram
65
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:36:17 1998
Color profile: Disabled
Composite Default screen