Media and ribbon requirements 3, Unpacking 3, Leaving the program mode – Zebra Technologies XiII-Series User Manual
Page 43

Leaving the Program Mode
You can leave the Program Mode at any time by pressing the Setup/Exit
key. The SAVE CHANGES display will appear. There are five choices,
described below. Pressing the left or right black oval key displays other
choices and pressing the Next/Save key selects the displayed choice.
n
PERMANENT - permanently saves the changes. Values are stored in
the printer even when power is turned off.
n
TEMPORARY - saves the changes until changed again or until power
is turned off.
n
CANCEL - cancels all changes since pressing the Setup/Exit key except
the Darkness and Tear-Off settings (if they were changed).
n
LOAD DEFAULTS - loads factory defaults. The factory defaults are
shown on the following pages.
NOTE: Loading factory defaults will require ptinter calibration and
resetting the Head Resistor value.
n
LOAD LAST SAVE - loads values from the last Permanent Save.
Zebra XiII-Series User’s Guide
31
43
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:35:48 1998
Color profile: Disabled
Composite Default screen