Zebra Technologies XiII-Series - Manual (Page 59)

4. Copy the file to the Zebra XiII printer.
NOTE: Typically, computers running DOS use the “COPY” command to
send a file to the Zebra printer. For example, if your file name is
“format1.zpl” then type, “COPY FORMAT 1.ZPL XXXX”, where
“XXXX” is the port to which your Zebra printer is connected, for
example, “COM1" or ”LPT1".
5. Compare your results with those shown. If your printout does not look
like the one shown, confirm that the file you created is identical to the
format shown, then repeat the printing procedure. If nothing prints,
refer to the “Getting Started” section to make sure your system is set
up correctly, otherwise refer to the “Troubleshooting and Diagnostics”
section.
Zebra XiII-Series User’s Guide 47
59
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:35:52 1998
Color profile: Disabled
Composite Default screen