ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 237)

GS-3012/GS-3012F User’s Guide
Command Examples 31-15
Syntax:
egress set
where
Sets the outgoing traffic port list for a port-based VLAN.
This command adds a port into the port-based VLAN. When you use the port-based VLAN, all of the ports are
members by default. You must use the no egress set command to remove ports if you do not want all ports
to be members. An example is shown next.
Enable port-based VLAN tagging on the switch.
Enable ports one, three, four and five for configuration.
Remove all ports (one through 12) from the VLAN.
Add ports 0, 6 and 7~9 as outgoing ports for the VLAN.
Figure 31-30 egress set Command Example
31.8.12 qos priority
Syntax:
qos priority <0 .. 7>
where
<0 .. 7> Sets the quality of service priority for an interface(s).
An example is shown next.
Enable ports one, three, four and five for configuration.
Set the IEEE 802.1p quality of service priority as four (4).
Figure 31-31 qos priority Command Example
31.8.13 name
Syntax:
name
where
string> Sets a name for your port interface(s).
ras(config)# vlan-type port-based
ras(config)# interface port-channel 1,3-5
ras(config-interface)# no egress set 0-12
ras(config-interface)# egress set 0,6,7-9
ras(config)# interface port-channel 1,3-5
ras(config-interface)# qos priority 4