ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 168)

GS-3012/GS-3012F User’s Guide
24-4 Access Control
24.3.3 Configuring SNMP
From the Access Control screen, display the SNMP screen. You can click Access Control to go back to the
Access Control screen.
Figure 24-4 Access Control: SNMP
The following table describes the labels in this screen.
Table 24-4 Access Control: SNMP
LABEL DESCRIPTION
Get Community Enter the get community, which is the password for the incoming Get- and GetNext- requests
from the management station.
Set Community Enter the set community, which is the password for incoming Set- requests from the
management station.
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP manager.
Trap Destination Enter the IP addresses of up to four stations to send your SNMP traps to.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring this screen afresh.
24.3.4 Setting Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the switch via web configurator at
any one time.
1. An administrator is someone who can both view and configure switch changes. The username for the
Administrator is always admin. The default administrator password is 1234.
It is highly recommended that you change the default administrator password ("1234").
2. A non-administrator (username is something other than admin) is someone who can view but not configure
switch changes.