ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 220)

GS-3012/GS-3012F User’s Guide
30-26 Introducing the Commands
Table 30-5 Command Summary: Interface
COMMAND DESCRIPTION
ingress-check Incoming traffic is not checked
for VLAN tags.
intrusion-lock
Disables intrusion-lock on a port
so that a port can be connected
again after you disconnected the
cable.
mirror Disables port mirroring on the
switch.
multicast-limit Disables multicast limit on the
switch.
vlan-trunking Disables VLAN trunking on the
switch.
pvid <1-4094> The default PVID is VLAN 1 for
all ports. Sets a PVID in the
range 1 to 4094 for the specified
interface.
qos priority <0 .. 7> Sets the quality of service priority
for an interface.
speed-duplex
half|100-full|1000-full>
Sets the duplex mode (half, full)
and speed (10/100/1000 Mbps)
of the connection on the
interface. Selecting auto (auto-
negotiation) makes one port able
to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
spq Sets the interface to use Strict
Priority Queuing.
test Performs an interface loopback
test.
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
switch.
wrr Sets the interface to use
Weighted Round Robin queuing
(WRR).
30.9.6 mvr Commands
The following table lists the mvr commands in configuration mode.