ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 217)

GS-3012/GS-3012F User’s Guide
Introducing the Commands 30-23
Table 30-4 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
ip address
inband-default
dhcp-bootp
Sets the default in-band interface to use
a static IP address in this VLAN.
The switch will use the default IP
address of 0.0.0.0 if you do not
configure a static IP address.
untagged
list>
Specifies the port(s) you want to tag all
outgoing frames transmitted with this
VLAN Group ID.
normal Specifies the port(s) to dynamically join
this VLAN group using GVRP
untagged
list>
Specifies the port(s) you don’t want to
tag all outgoing frames transmitted with
this VLAN Group ID.
30.9.5 interface Commands
The following commands are listed in configuration mode as “interface” switch commands; all are preceded with
the command
interface.
Table 30-5 Command Summary: Interface
COMMAND DESCRIPTION
interface
port-
channel
list>
Enables a port or a list of ports
for configuration.
bandwidth-limit Enables bandwidth limit on the
switch.
cir Sets the guaranteed bandwidth
allowed for incoming traffic on
the port(s).
egress Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
ingress Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
pir Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
broadcast-limit Enables broadcast storm control
limit on the switch.
Sets how many broadcast
packets the interface receives
per second.