Telenetics 56 User Manual
Page 77
AT Commands
Page 69
*B - Display Blacklisted Numbers
This command requests the modem to return a list of blacklisted numbers to the DTE.
The format of the response is shown by the example below. Permanently forbidden
numbers as defined by country requirements will not appear on this list. If no numbers
are blacklisted, only the OK result code is issued.
Syntax
*B
Example
NO. - PHONE NUMBER -------
------------------------------
1; 4175537660
2; 8288924961
3; 3887278862
4; 3124839442
5; 6284664
OK
*D - Display Delayed Numbers
This command causes the modem to send a list of the delayed numbers together with the
delay associated with each. The modem will return a list of delayed telephone numbers as
defined in the *B command. The format of the response is shown by the example below
(delay times are shown as hours:minutes:seconds). If no numbers are delayed, only the
OK result code is issued.
Syntax
*D
Example
NO. - PHONE NUMBER -DELAY
------ -------------------------------------------
1; 8264734660 2:00:00
2; 7532634661 2:00:00
3; 2587334662 0:02:00
4; 7532651663 0:03:25
5; 7459931664 0:01:45
OK
–PPD= - Extension Pickup Notification through 16550 UART
The –PPD=1 command allows setting of the DDSR (bit 1 of register 6) when an
extension pick-up is detected, and disables all DSR notification. The –PPD=0 command
disables this feature.
This feature is available only on a SmartSCM that is configured for parallel operation.