Telenetics 56 User Manual

Page 150

AT Commands

Page 142

Mode Commands

+FAA - Auto Answer Enable

This command enables or disables fax adaptive answer. This command operates
identically to the +FAE command.

Syntax

+FAA=

Defined Value

Decimal number corresponding to the selected option.

0 Disable data /fax auto answer mode. (Default.)

1 Enable data /fax auto answer mode. The modem

determines the calling type and issues DATA result
code (13) if the caller is a data modem or issues FAX
result code (15) if the caller is a fax

+FAE - Auto Answer Enable

This command enables or disables fax adaptive answer. This command operates
identically to the +FAA command.

Syntax

+FAE=

Defined Value

Decimal number corresponding to the selected option.

0 Disable data /fax auto answer mode. (Default.)

1 Enable data /fax auto answer mode. The modem

determines the calling type and issues DATA result
code (13) if the caller is a data modem or issues FAX
result code (15) if the caller is a faxmodem.

After a data (not fax) connection is achieved (indicated by the DATA result code), the
DTE must issue an ATO command to cause the modem to go on-line.

+FTS - Transmit Silence

This command causes the modem to terminate a transmission and wait for 10-ms
intervals before responding with the OK result code.

Syntax

+FTS=

Defined Value

Decimal number from 0 (default) to 255 which specifies the

length of time in 10-ms intervals to delay before responding
with the OK result code after terminating the session.

Result Codes

OK Reported when transmission has been terminated for the

specified amount of time.

ERROR is invalid or this command is issued while the modem

is on-hook.

Reporting Supported Range of Parameter Values

Command: +FTS=?
Response:

+FTS: range