Telenetics 56 User Manual
Page 75
AT Commands
Page 67
Digital Loss................ 2000
Local Rtrn Count............ 00
Remote Rtrn Count........... 00
Flex 9481814347C4
RBS Pattern: Shows which bits are being robbed in the least significant 6 bytes, e.g., 03
indicates 2 robbed bits in bit positions 0 and 1.
Digital Loss: Shows if a pad was encountered and if so, what was the digital loss. 2000
means 0dB.
Flex: Shows V.8bis information as follows:
First byte: Octet 13 (second byte of manufacturer id, 94 = K56flex)
Second byte: Octet 14 (Licensee code: 81 = Conexant)
Third byte: Octet 15 (manufacturer's product capabilities)
Fourth byte: Octet 16 (K56flex version number)
Fifth byte: Octet 17 (Conexant pump code version number)
Sixth byte: Octet 18 (x-law and controller version number)
Bit 6
Forced/Not forced A-Law/µ-Law
0 = Forced A-Law/µ-Law.
1 = Not forced A-Law/µ-Law.
Bit 5
Select A-Law or µ-Law
0 =
Select A-Law.
1 = Select µ-Law.
Bit 4:0 Controller version
\V - Single Line Connect Message Enable
This command enables or disables the single line connect message format as follows:
Syntax
\V
Defined Values
0 Connect messages are controlled by the command
settings X, W, and S95.
1 Connect messages are displayed in the single line
format described below subject to the command
settings V (Verbose) and Q (Quiet). In Non-Verbose
mode (V0), single line connect messages are disabled
and a single numeric result code is generated for
CONNECT DTE.
When single line connect messages are enabled, there are no CARRIER,
PROTOCOL (+ER:), or COMPRESSION (+DR:) messages apart from the fields
described below.
The single line connect message format is:
CONNECT
Where:
DTE Speed = DTE speed, e.g., 57600.