Telenetics 56 - Manual (Page 113)

AT Commands
Page 105
V.92 +P and –Q Commands
This section describes the +P (PCM DCE) and –Q commands and parameters used to
control the V.92 Mode operation.
+PCW - Call Waiting Enable
This command controls the operation of the modem in the presence of call waiting.
Syntax +PCW=
Defined Value
Decimal number corresponding to the selected operation.
0 Request modem-on-hold if enabled by +PMH and
collect caller ID information if enabled by +VRID.
Toggle V.24 circuit 125. (Default.)
1 Hang-up.
2 Ignore call waiting.
Result Codes
OK = 0, 1, or 2.
ERROR Otherwise.
Reporting Selected Values
Command: +PCW?
Response: +PCW:
Example: +PCW: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PCW?
Response:
+PCW: ( range)
Example: +PCW: (0,1,2)
+PMH - Modem-on-Hold Enable
This command controls the selection of modem-on-hold in the modem. The action of the
modem in response to modem-on-hold events is determined by the state of this command
as well as the state of a negotiated handshake with a V.92-compliant server in V.92
Mode.
Syntax +PMH=
Defined Value
Decimal number corresponding to the selected operation.
0 Modem-on-hold enabled in V.92 Mode. (Default.)
1 Disabled modem-on-hold.
Result Codes
OK 0 or 1 in V.92 Mode (see the +MS command)
ERROR Otherwise.
Reporting Selected Values
Command: +PMH?
Response:
+PMH:
Example: +PMH: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PMH?
Response:
+PMH: ( range)
Example: +PMH: (0,1)