Telenetics 56 - Manual (Page 176)

AT Commands
Page 168
+FK - Session Termination
Syntax +FK
The +FK command causes the DCE to terminate the session in an orderly manner. In
particular, the DCE will send a DCN message at the next opportunity and hang up. At the
end of the termination process, the DCE will report the +FHNG response with result
code (Table A-26). This operation can be invoked by using the cancel character
during Phase C data reception (see prior section). The DCE will wait until the current
page completes, unless the reception is of unlimited length; in that case, the DCE may
halt reception and terminate the session at any time.
+FCIG - Set Polling ID
This command allows setting the Local Polling ID string used in a CIG frame. The
syntax of this command is identical to +FLID.
Write syntax: +FCIG=""
Valid value: 20-character ASCII string
Default value: Empty
+FLPL - Indicate a Document for Polling
This command allows setting up an answering modem to know that it has a document
available for polling. This allows a calling modem to receive this fax from the answerer.
The syntax is:
AT+FLPL=?
0,1
OK
AT+FLPL=1
OK
AT+FLPL?
1
+FSPL - Enable Polling
This command allows setting up an originating modem to be able to request to receive a
document from a polled station. The syntax is:
AT+FSPL=?
0,1
OK
AT+FSPL=1
OK
AT+FSPL?
1