Telenetics 56 - Manual (Page 56)

AT Commands
Page 48
DTE-Modem Interface Commands
The parameters defined in this section control the operation of the interface between the
DTE and modem.
E - Command Echo
The modem enables or disables the echo of characters to the DTE. The parameter value,
if valid, is written to S14 bit 1.
Syntax E
Defined Values
Decimal number corresponding to the option.
0 Disables command echo.
1 Enables command echo. (Default.)
Result Codes
OK = 0 or 1
ERROR Otherwise.
Q - Quiet Results Codes Control
The command enables or disables the sending of result codes to the DTE. The parameter
value, if valid, is written to S14 bit 2.
Syntax Q
Defined Values
Decimal number corresponding to the option.
0 Enables result codes to the DTE. (Default.)
1 Disables result codes to the DTE.
Result Codes
OK = 0 or 1
ERROR Otherwise.
V - Result Code Form
This command selects the sending of short-form or long-form result codes to the DTE.
The parameter, if valid, is written to S14 bit 3.
Syntax V
Defined Values
Decimal number corresponding to the option.
0 Enables short-form (terse) result codes. Line feed is
not issued before a short-form result code.
1 Enables long-form (verbose) result codes. (Default.)
Result Codes
OK = 0 or 1
ERROR Otherwise.