Telenetics 56 - Manual (Page 67)

AT Commands
Page 59
+IFC - DTE-Modem Local Flow Control
This extended-format compound parameter controls the operation of local flow control
between the DTE and the modem during the data state when V.42 error control is used,
or when fallback to non-error control mode is specified to include buffering and flow
control. It accepts two numeric subparameters
Syntax +IFC=[[,]]
Defined Values
Specifies the method to be used by the DTE to control the
flow of received data from the modem.
0 None.
1 XON/XOFF on transmitted data (XON/XOFF on
transmit data); do not pass XON/XOFFcharacters
to the remote modem.
2 Circuit 133 (Ready for Receiving). (Default.)
DC1/DC3 on circuit 103 (Transmitted Data) with
DC1/DC3 characters being passed through to the
remote DCE in addition to being acted upon for
local flow control
Specifies the method to be used by the modem to control the
flow of transmitted data from the DTE.
0 None.
1 XON/XOFF on received data.
2 CTS/RTS. (Default.)
Reporting Current or Selected Values
Command: +IFC?
Response: +IFC:,
Example:
+IFC: 2,2 For the defaults.
Reporting Supported Range of Parameter Values
Command: +IFC?
Response: +IFC:
( range),(
range)
Example: +IFC: (0-3),(0-2)
+ILRR - DTE-Modem Local Rate Reporting
This extended-format numeric parameter controls whether or not the extended-format
+ILRR:<rate> information text is transmitted from the modem to the DTE
Syntax +ILRR=
Defined Values
Decimal number corresponding to the selected option.
0 Disables reporting of local port rate (+ILRR: is not
transmitted).(Default.)
1 Enables reporting of local port rate (+ILRR: is
transmitted).
Reporting Current or Selected Values
Command: +ILRR?
Response:
+ILRR:
Example: +ILRR: 0 For the default setting
Reporting Supported Range of Parameter Values
Command: +ILRR=?