Telenetics 56 - Manual (Page 115)

AT Commands
Page 107
2 MOH with 20 second timeout Granted.
3 MOH with 30 second timeout Granted.
4 MOH with 40 second timeout Granted.
5 MOH with 1 minute timeout Granted.
6 MOH with 2 minute timeout Granted.
7 MOH with 3 minute timeout Granted.
8 MOH with 4 minute timeout Granted.
9 MOH with 6 minute timeout Granted.
10 MOH with 8 minute timeout Granted.
11 MOH with 12 minute timeout Granted.
12 MOH with 16 minute timeout Granted.
13 MOH with indefinite timeout Granted.
Result Codes
OK 0-13 in V.92 Mode (+MS=V92)
ERROR Otherwise.
+PIG - PCM Upstream Ignore
This command controls the selection of PCM upstream in the modem. The actual state of
PCM upstream is determined by the state of this command as well as the state of a
negotiated handshake with a V.92-compliant server in V.92 Mode.
Syntax +PIG=
Defined Value
Decimal number corresponding to selected operation.
0 Enable PCM upstream negotiation.
1 Disable PCM upstream negotiation. (Default.)
Result Codes
OK 0 or 1 in V.92 Mode (+MS=V.92)
ERROR Otherwise.
Reporting Selected Values
Command: +PIG?
Response: +PIG:
Example: +PIG: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PIG?
Response:
+PIG: ( range)
Example: +PCW: (0,1)
+PMHF - V.92 Modem-on-Hold Hook Flash
This command causes the modem to initiate the flash hook sequence when in the modem-
on- hold procedure. This enables switching to the second call (incoming or outgoing).
This command applies only to V.92 modem-on-hold. There are no parameters associated
with this command.
Syntax +PMHF
Result Codes
OK When the modem completes the flash hook sequence.
ERROR If this command is initiated and the modem is not on hold.