Telenetics 56 - Manual (Page 119)

AT Commands
Page 111
FACTORY DEFAULTS
The factory default values are stored in ROM and are loaded into the active configuration
at power up or by the ATZ command. In addition, the designated default profile is
subsequently loaded, and may change some of the factory default values. The designated
default profile can be changed by entering the &Y command where n is one of the two
possible user profiles.
The defaults shown are those used by Conexant in factory profiles zero and one. These
may be overwritten by the OEM with ConfigurACE prior to placing the firmware in
PROM. Minimum and maximum values may also be imposed by ConfigurACE in
response to country PTT requirements.
The default values shown in Table A-14 may vary by modem firmware configuration.
Consult the MCU firmware release notes for exact configuration.
The factory default values may be loaded at any time by entering the &Fn command.
Table A-14. S-Parameter Summary
Register Function
Rang
e Units Saved Default**
S0 Rings to Auto-Answer 0-255 rings * 0
S1 Ring Counter 0-255 rings 0
S2 Escape Character 0-255 ASCII * 43
S3
Carriage Return
Character 0-127
ASCII 13
S4 Line Feed Character 0-127 ASCII 10
S5 Backspace Character 0-255 ASCII 8
S6
Wait Time before Blind
Dialing or for Dial Tone
2-255 s * 2
S7
Wait Time for Carrier,
Silence, or Dial Tone
1-255 s * 50
S8
Pause Time for Dial
Delay Modifier
2-255 s * 2
S9
Carrier Detect Response
Time
1-255 0.1 s * 6
S10
Lost Carrier To Hang Up
Delay
1-255 0.1 s * 14
S11 DTMF Tone Duration 50-255 0.001 s * 95
S12
Escape Prompt Delay
(EPD)
0-255 0.02 s * 50
S14
General Bit Mapped
Options Status
- - 138 (8Ah)
S16
Test Mode Bit Mapped
Options Status
- - 0
S19 Reserved - - 0
S20 Reserved - - 0
S21
V.24/General Bit
Mapped Options Status
- - 52 (34h)