Telenetics 56 - Manual (Page 188)

Page 180
Voice Commands
Voice Commands Overview
Voice commands are identified in Table A-29.
Table A-29. Voice Commands
Command Function
Configuration
+FCLASS Set
Mode
+VCID Caller ID (CID)
+VNH Automatic Hang-up control
+FMI? Manufacturer Identification
+FMM? Product Identification
+FMR? Version, Revision, etc.
+FLO Flow Control
Voice
+VIP
Voice Initialize All Parameters
+VRX Start modem Receive (Record)
+VTS Voice Tone Send (Send single frequency or DTMF)
+VTX Start modem Transmit (Playback)
+VGR Voice Gain Receive (Record Gain)
+VGT Voice Gain Transmit (Playback Volume)
+VIT Voice Inactivity Timer (DTE/Modem)
+VLS Analog Source/Destination Selection
+VRA Ringback Goes Away Timer
+VRN Ringback Never Appeared Timer
+VSD Silence Detection (QUIET & SILENCE)
+VSM Compression Method Selection
+VTD Beep Tone Duration Timer
+VDR Distinctive Ring
+VDT Control Tone Cadence Reporting
+VPR Select DTE/modem Interface Rate (Turn off autobaud)
Speakerphone
+VSP Speakerphone
ON/OFF
+VDX Speakerphone Duplex Mode
+VGM Microphone Gain
+VGS Speaker Gain