Telenetics 56 - Manual (Page 68)

AT Commands
Page 60
Response: +ILRR: ( range)
Example: +ILRR: (0,1)
Reported Rate
The reported represents the current (negotiated or renegotiated) DTE-
modem rate. If enabled, the intermediate result code is transmitted after any
modulation, error control or data compression reports are transmitted, and before
any final result code (e.g., CONNECT) is transmitted. The is applied after
the final result code is transmitted.
The DTE-modem port rate will change only if neither buffered mode nor error
controlled means are enabled (+ES=x,0) and if the negotiated carrier rate (+MRR)
does not match the current DTE-modem port rate (auto-detected from the previous
command line).
Syntax
+ILRR: [,]
Defined Values
Decimal value representing Decimal value representing the
current (negotiated or renegotiated) DTE-modem rate:
0-9, 300, 1200, 2400, 4800, 9600, 19200, 38400,
57600, 115200, or 230400
Optional decimal value reporting the RXD rate, if it is different
from the TXD rate:
0, 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200, or 230400
Example: +ILRR: 19200
Call Control
D - Dial
This command directs the modem to go on-line, dial according to the string entered and
attempt to establish a connection. If no dial string is supplied, the modem will go on-line
and attempt the handshake in originate mode.
NOTE: If the ATD command is issued before the S1 register has cleared, the modem
will respond with the NO CARRIER result code.
If +FCLASS=0 is selected, the modem will behave as a data modem and will attempt to
connect to another data modem. The modem will have up to the period of time specified
by register S6 or S7 to wait for carrier and complete the handshake. If this time expires
before the modem can complete the handshake, the modem will go on-hook with the NO
CARRIER response. This command will be aborted in progress upon receipt of any DTE
character before completion of the handshake.
If +FCLASS=1, 1.0, or 2 is selected, the modem will behave as a facsimile modem and
attempt to connect to a facsimile machine (or modem) by entering the HDLC V.21
channel 2 receive state (as if +FRH=3 had been issued). This command will be aborted
upon receipt of any DTE character if the modem has not finished dialing. In this case, the
modem will go on-hook and return to command mode after displaying the NO