Telenetics 56 - Manual (Page 112)

AT Commands
Page 104
:E - Compromise Equalizer Enable Command
This command is included for compatibility only and has no effect other than returning a
result code.
Syntax :E
Defined Value
Decimal number corresponding to the selected option.
0 :E0 command.
1 :E1 command.
.
30 @M30 command.
Result Codes
OK 0 or 1.
ERROR Otherwise.
FastConnect Commands
$F – FastConnect Control
This command allows configuring of the client modem to connect to a central site modem
that supports non-standard V.22 and V.22bis FastConnect protocols.
Syntax $F
Defined Value
Decimal number which specifies the initial requested mode of
operation when the modem is operating as the originator. The
options are:
0 Normal connection (Default)
1 FastConnect without answer tone
2 Reserved
3 FastConnect with answer tone
Result Codes
OK 0 or 1.
ERROR Otherwise.