Telenetics 56 - Manual (Page 145)

AT Commands
Page 137
Table A-17. Fax Class 1 and Fax Class 1.0 Commands
Command/Paramete
r Function
Applicable
in Fax
Class 1 Applicable
in Fax
Class 1.0
+FCLASS= Select, read or test service
class X X
+FAA= Auto answer enable - X
+FAE= Auto answer enable X X
+FTS= Stop transmission and pause X X
+FRS= Wait for silence X X
+FTM= Transmit data with
carrier X X
+FRM= Receive data with
carrier X X
+FTH= Transmit HDLC data with
carrier X X
+FRH= Receive HDLC data with
carrier X X
+FAR= Adaptive reception control - X
+FCL= Carrier loss timeout - X
+FDD= Double escape character
replacement control - X
+FIT=,
DTE inactivity timeout - X
+FPR= Fixed DTE Rate - X
+FMI? Report manufacturer ID - X
+FMM? Report model ID - X
+FMR? Report revision ID - X
+FLO Flow Control - X
&K Local DTE-modem flow control X X
A Answer X X
D strin Dial X X
H Hangup X X
X = Applicable; - = Not applicable.
Fax Origination
Origination of fax calls is made using the ATD command. Upon completion of the dial
function, a calling tone at 1100 Hz is transmitted, with a cadence of 0.5 seconds on and 3
seconds off. The modem automatically enters mode +FRH=3 and sends the CONNECT
message to the DTE when FSK flags are detected from the remote.