Telenetics 56 User Manual
Page 153
AT Commands
Page 145
+FRM - Receive Facsimile
This command causes the modem to enter the receiver mode using the modulation
defined below.
Syntax
+FRM=
Defined Value
mode and data rates shown in Table A-18.
Reporting Current or Selected Values
Command: +FRM?
Response: +FRM:
Example:
+FRM: 98
For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FRM?
Response:
+FRM: (
Example: +FRM:
3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes
CONNECT Reported when the selected carrier is detected.
+FCERROR Reported if another carrier is detected and FAR=0; the modem
then returns to the command state.
NO CARRIER Reported if loss-of-carrier is detected.
OK Reported if the DTE sends any character to the modem other
than XON or XOFF while operating in configured flow control
from the DTE; the modem then returns to the command state.
+FTH - Transmit Data with HDLC Framing
This command causes the modem to transmit data using HDLC protocol and the
modulation defined below.
Syntax
+FTH=
Defined Value
mode and data rates shown in Table A-18.
Result Codes
CONNECT Reported for either of two conditions:
1. At the beginning of transmission of the training
pattern for the selected modulation.
2. if the Final Frame bit is 0.
OK Reported for either of two conditions:
1. If the Final Frame Bit is 1.
2. if the DTE sends only
while transmitting flags.
ERROR Reported if five seconds elapse from the time when the modem
reported the CONNECT result code without any additional data
transmitted from the DTE; the modem then turns off carrier and
returns to the command mode.
Reporting Current or Selected Values
Command: +FTH?
Response: +FTH:
Example:
+FTH: 98
For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FTH?