Telenetics 56 User Manual
Page 173
AT Commands
Page 165
The remote facsimile station should respond to the post page message with a post page
response. The DCE will report this using the +FPTS:
End a Page
The +FET= command causes the DCE to append an RTC (6 EOL) pattern as needed and
enter Phase D by sending the selected T.30 Post Page message.
The +FET=1 (EOM) command signals the remote station that the next document will
have a new DCS negotiated; this causes the session to re-enter Phase B.
Table A-24. T.30 Post Page Message Codes
ppm Code
Mnemonic
Description
0
[PPS-]MPS
Another page next, same document
1
[PPS-]EOM
Another document next
2
[PPS-]EOP
No more pages or documents
3
PPS-NULL
Another partial page next
4
[PPS-]PRI-MPS
Another page, procedure interrupt
5
[PPS-]PRI-EOM
Another doc., procedure interrupt
6
[PPS-]PRI-EOP
All done, procedure interrupt
=8+ppm
Post Page Message (ppm code)
Table A-25. T.30 Post Page Response Messages
ppr Code
Mnemonic
Description
1
MCF
Page good
2
RTN
Page bad; retrain requested
3
RTP
Page good; retrain requested
4
PIN
Page bad; interrupt requested
5
PIP
Page good; interrupt requested