Telenetics 56 - Manual (Page 117)

AT Commands
Page 109
-QCPC - Force Full Startup Procedure Next Connection
This command causes the modem to use full startup procedures on the next connection
attempt regardless of the setting of the +PQC command. After this attempt, the modem
will select the startup procedure as defined by the +PQC command. If a shortened startup
procedure is enabled by the +PQC command, then the quick connect profile will also be
updated on the next connection attempt.
Syntax -QCPC
Result Codes
OK In V.92 Mode (+MS=V.92)
ERROR Otherwise.
-QCPS - Enable Quick Connect Profile Save
This command controls whether or not the modem will save the generated quick connect
profile.
Syntax -QCPS=
Defined Value
Decimal number corresponding to the desired operation.
0 Do not allow the quick connect profile to be saved.
1 Allow the quick connect profile to be saved. (Default.)
Result Codes
OK 0 or 1 in V.92 Mode (+MS=V.92) and quick connect is enabled
(+PSS = 0)
ERROR Otherwise.
Reporting Selected Value(s)
Command: QCPS?
Response: QCPS:
Example: QCPS: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: -QCPS=?
Response:
-QCPS: ( range)
Example: -QCPS: (0,1)